Search results

Aprantly I've mugged some one selling them a forged but non forged R lol when I sold the car 7/8months ago and past threw couple hands it seems but yet I've been blamied lol I sold the car with it needed work to either turbo or engine and the advert Is on here not stating any where about a...

http://page.mixi.jp/recent_page_feed.pl?page_id=31738&module_id=166508

Hi guys after a 3.5 or 4 inch tip for a goose just looking for slightly bigger than my 3 inch one and not as big as the 5 lol

Got this lot to do over the weekend lol

hi guys im after the long bottom alternator bolt,

Hi guys, have a technical issue here and I'm sure it's down to me, when I bought the car the boost controller played up so thought il do the old plum it in threw standard soilinoid and use a 1.2mm restrictor this worked ok to reach .9bar and like the fact still controlled by the ecu, latley...

As titled or least drivers side shaft

Anyone going to this summer evening event thing? Been pushed into taking the r out up there and wondered if any fellow R's are going

Been away for a while and i know comp stuff changes daily. So what is there to offer on the Ecu side of things now? can we go map sensor easy enough? is motec still only one to offer this? whats the new emanger like etc, talk to me please guys, apexi power fc still bang for buck?? would like to...

Just out of interest what you think she's worth ? My91 Gti-R imported in 2007 was owned by a friend, sold and bought by me. 3owners 100kmh on the clock with mots to prove totally totally rot free archs are amazing, only mods are, 17inch compos (rare) hispec billet 4pots in mint condition , red...

Hi guys after a alternator, think the bearing has gone on mine and sounds awfull looking for one posted or close in easy Sussex area

hi all im after the two half moon brackets the sump quard plate mounts on with please.

Mornig guys, I'm still after some advice, My tick over issue, i have had the car for over a month and still cant get this tick over issue sorted, In the mornings from cold, sits around 1800rpm, leave to warm for up to a min, i'll drive down the road and once pulled up to the junction she will...

Don't know if you guys have seen this before but loving it, the little splitter for stock bumper is yummy why wont someone over here make it as id snap one up, http://crazyhornet.com/?mode=cate&cbid=1460299&csid=0

hi, im after a stock pulsar drivers side matt, cheers

hi guys im after the brackets that hold the stereo in, cheers

Guys looking to get some 16inch rotas instead of my 17s, question is will 16x7 with a et40 fit over the hispec billet 4pots? keep reading that the R drive much better on 16s is this right? Cheers

hi guys try searching to no luck does any one have a pic of the cold start i need to clean mine out and i havnt a clue where it is

hi guys, before shouting, yes ive tried the search button :-), My new R idles from cold at 1800rpm and hot 15-1600 Few times has settled at 1k not much at all tho, seems if you give it some it will settle better, I'm not liking the high idle at cold start tho, Things i've done so far, Checked...

sold .....