Search results

So the car was parked up for about a month. Started it up and its burbling like a scooby. Drove it up the road and goes like it has only 5 hp. Spark plugs are new. Suspected it had some sort of air leak before cos was idling at 1200 and would intermittently and very faintly come off power for a...

What are everyone's experiences on track days? Is it ok track pulsars every now and then or will the gearbox not last the ordeal?

Does the 300ZX one fit? Heard it's an upgrade on the R one

Where can i get a decent one from? And how does the 3071r compare? Looking for quick spooling turbo and 400+ bhp

Are the strengthning plates (plates with the round holes) necessary or can the car do without them? Only that mines were rusted so were cut from the bottom half (as you can see), but not sure if they were repaired and re-welded to the sills.

K-Mac make camber and caster adjustable top mounts for the Rs but not sure if they will fit the Tien SS coilovers I have. What measurements do I need to take? K-Mac said they've been designed to fit the Tien SSs and will fit 60-70mm but what does that measurement pertain to?

A few questions here: 1. Whats the standard diff type and set up on the front, centre and back(1 way i imagine?) 2. What's the Nismo diff type and setup? 3. Which is the best option to go with on the R? 4. Which brand (have seen Quaife, Cusco and Modena)? Cheerz

24 April 2016 - Silverstone http://www.japfest.co.uk/japfesthome The Silverstone Classic is a bit pricey for me so I suppose this is next best thing.

The bonnet scoop is iconic, but is it efficient in terms of heat transfer? If you have a front mount intercooler, all the scoop does (because of the way it's facing) is pull in air and trap it under the bonnet, right? Also from an aero perspective, doesn't it just cause massive drag? There are...

@ Santa Pod. Anyone going?

Was at Santa Pod yesterday at the Ultimate Street Car event and decided to go up the 1/4 mile for the first time. Unfortunately can't say I done the Rs proud. Had 3 runs and 14.2 is the best I got :cry:. Came up against an E46 M3 and took it off the line with a 5k rpm launch but shifted a bit...

Here's my situation. Car is rusted out from underneath. Never noticed it when buying the car and even though I had it on ramps a few times at a couple of different garages for work that needed doing, none of them spotted the rust and I carried on spending on the car thinking the body was good...

Anyone know where I can get new sills from?

Looking to increase the power a bit so just need some advice on what changes are needed for a reliable 350 bhp output. 1. How far can the standard injectors, MAF and ECU be be tuned for? I've heard different things so am a bit unsure at the moment. 2. I have a Mine's ECU. What is the breaking...

1. This one has the rare fog lights: Nissan Sunny Pulsar GTIR WIDEARCH | eBay Anyone know where to get a similar rear bumper from? 2. This one needs a bit of work but has good potential: Nissan Pulsar GTI-R, GTIR Forged | eBay

Will it pass without the cat? If not, how many/which cats will I need and where can I get them from for a goose system? Wil the std R one fit?

I'm planning to have the setup sorted soon but have a few questions (am a relative novice when it comes to these things so please forgive my ignorance). 1. I've read the standard caster is +2 degrees and that I should be around +4 for the street. I've got the Whiteline anti-lift kit fitted so...

Anyone bought anything from Nengun performance in Japan? Parts Search - Nengun Performance They seem to have a lot of aftermarket parts for the R, even Cusco LSDs, OS Giken gear sets and all manner of engine internals. I contacted them once about their KYBs but though they responded quickly...

Hi guys, I don't know how it happened but I managed to pick up some brand new unused and unopened Tein coilovers with top mounts very very cheap. I do need new suspension all round but was advised that Meister are v good. So now I'm thinking I could sell the Teins and get Meisters instead and...

Thinking of getting a Fidanza flywheel but don't know if it will go with my Exedy Stage 1 clutch. Is anyone else running this combo?