R
rocketship4
Guest
G'day guys,
Long time reader, late member here.
Just wanted some experienced opinions on my situation.
I had my motor rebuilt a while back with all standard parts including Nissan .2mm oversize pistons.
I have looked after this motor, however I now find myself with a GT3037 turbo and wanting around 350-400hp atw.
I will be purchasing over the next couple of months engine management, injectors, cams, valve springs, head gasket etc.. However, should I trust the std pistons and rods? or would it be mandatory to get some rods and pistons and send the block off to be machined again?
Thanks for any thoughts/advice on the matter.
Geoff.
Long time reader, late member here.
Just wanted some experienced opinions on my situation.
I had my motor rebuilt a while back with all standard parts including Nissan .2mm oversize pistons.
I have looked after this motor, however I now find myself with a GT3037 turbo and wanting around 350-400hp atw.
I will be purchasing over the next couple of months engine management, injectors, cams, valve springs, head gasket etc.. However, should I trust the std pistons and rods? or would it be mandatory to get some rods and pistons and send the block off to be machined again?
Thanks for any thoughts/advice on the matter.
Geoff.