Recent content by PUL54R

Check the battery warning light in the instrument panel, I'm not saying this will be the cause but I had something similar on a vauxhall a while back. Basically the alternator wasn't charging cos it needed a 12v signal to turn it on, this is supplied from the ignition through the bulb and into...

I'm sure I have an old turbo at work, bearings went on it but the casing may be ok, i will have a look tomorrow if it's any good. If you pay the postage you can have it?

Pm'd you.

I will sell both speedo and gauges for £25 posted

I have a set with White dials if your interested, also have the boost, oil pressure and oil temp gauges to match

Thats your ABS speed sensor

the smoke would most probably be from the old turbo, if the seals had gone then it will probably dump oil down the exhaust, this will eventually burn of with use. the hot/cold hoses depends on how long you had the car running, thermostat will open when the car is upto normal operating temp. you...

I would change the knock sensor before doing anything else first. I kept getting the same fault code, tried a second hand one I had which didn't work (should have gone for a new one first time!) then I started checking wiring and all sorts including another ecu. In the end after eliminating...

Clutch pipe isn't too bad to do. Remove the pipe from the maf to the turbo and you can see it, I got an updated braided one on mine now off eBay, probably cheaper than original Nissan one.

You should have a separate reservoir for clutch fluid which is near the brake servo, check the fluid level if it's empty chances are your clutch pipe on top of the gearbox has failed which is what happened to mine. Or it could be the master cylinder on the pedal or the slave cylinder that has...

For the main instrument panel you will need 3 501 type bulbs. These are the brown bulb holders, twist them out of the instrument panel and then pull the bulb out of the holder, fit your new bulbs and then refit into the instrument panel. If your using LEDs test they work before you refit...

I got some led bulbs from a site called ultimatemods.co.ukFor the speedo illumination you need 501 type bulbs, for the three centre gauges you need t5 wedge bulbsAnd for the switches you need heater wedge bulbs in 3mm

Hi I'm after a pair of doors in black, must be dent, rust and scratch free. I will travel if not too far as I don't trust couriers not to damage them, I'm in Wiltshire so let me know how far away you are and I'll consider it. Let me know what you have. Cheers.

Do you still have these for sale?

I may have a couple of spare ones, if I have your welcome to them, I will have a look at work tomorrow.