Wheel Nuts - Anthracite or Black in Colour

[antgtir]

As in the title im after a set of wheel nuts (lightweight ideally) for the R that are either anthracite or black in colour.

These are to be of good tried and tested quality and not these mickey mouse versions that need replacing everytime you remove them.

If anyone can point me in the right direction of where i can get some of these then i would be very grateful.

Look forward to hearing from you.

Best regards,

Ant.

 

[kenan]

I got some free with my rota wheels from www.rarerims.co.uk

The pain on them wasen't 100% but sure they would be cheap. Had them on and off a few times and seem ok.

 

[stevepudney]

ant as long as there made out of 7075 alloy or titanium you'll be fine, mine are made by ultralite and have been fine. To avoid damage get a 6 sided socket.

 

[vss irvine]

and dont let anyone near them with an impact gun.

 

[youngsyp]

Have a look on ebay.com mate. There are several sellers with them on there. The set I had my eye on are 7075 alloy and weigh about 0.6 oz each (around 20 grams). So, they're super lightweight.

Have a look here: http://cgi.ebay.com/ebaymotors/Lug-...62QQcategoryZ33749QQihZ017QQitemZ270230544609

Paul

 

[vss irvine]

ive bought from this seller before and have no complaints at all. very quick

 

[fubar andy]

Just buy some black steel ones Ant. ;-)

 

[JARS PulsR]

Ant,

I've got some McGard spline-drives on mine, seem pretty good and not that heavy at only 36g a piece.

They also come with useful rubber caps that fit over them to protect the finish.

Part codes are: 65003BK
You also need the 21mm hex adapter which is: 65100.

Not many places stock them, but I got mine from exclusive tuning and design.

Cost around £3.50 each

You can see some pics of them on my album here:

http://s247.photobucket.com/albums/gg137/JARS655/Pulsar_GTi-R/