hks super afr and apexi itc

[turbodaily]

anybody know if its possible to adjust this so its not doing anything??

i dont want it interfering with the fueling until its setup (think somebodys messed with it)

and also i have the apexi super itc (one with the little dials) if i set them all to zero will this mean its not doing anything? as i want this switched off aswell

was going to disconnect them completky from the loom but if i can just 'swithc them off' that would be alot easier for now

cheers

 

[ashills]

on the plug thats on the loom theres a cap to rejoin the airflow meter wire
so un plug the controller and stick the cap back in that will sort that

and the itc just set all dials to 0

 

[turbodaily]

cheers mate can you explain in more detail about the afr?

i had a look at the wiring coming from the afr, and theres a plug which is connected to another which goes down and joins to the main loom on the car, theres another plug on the back of the afr not connected to anything, and then theres a blue wire with a bullet connector from the afr loom which isnt connected to anything....