emanage ultimate and wideband

[ChrisS]

ANyone got a wide band hooked up to their ultimate. If so what sensor have you used and is the taget a/f map any good?

ta

 

[Fusion Ed]

Innovate LC1 will do the job fine. In fact any wideband with 0-5v output will be fine as you can calibrate it in the ultimate anyway.

 

[warringtonjack]

Sorry for the slight hijack, but would you be able to use an LC1 and wire it into an Apexi turbotimer so that the screen displayed the wideband a/f rather than the narrowband it picks up from the ecu? One for Ed prolly? :noidea:

 

[Fusion Ed]

Yes it could be done, but I d'ont know the input voltage range. It should be possible to configure it using the program used to control the output of the LC-1 so no reason why this wont work as I see it.

 

[ChrisS]

ed, have you used the target a/f map function at all and if so whats your opinion on it?

 

[Fusion Ed]

Its ok but you CANNOT leave it entirely to its own devices, and remember to turn it of when you have finished it or it will make a good job of totally ruining the fuel map..