compressor wheel?

T

turbodaily

New Member
just got this turbo, its a hybrid t28 with roller bearing core, .86 housing, the compressor wheel looks alot bigger than my old stage 1 turbo technics, as the inlet has been bored out. i remember my turbo technics hybrid wasnt the same size all the way through.. any idea what size wheel this looks like going by the pic below?

 
C

carlengerer

New Member
best way is to take off the comp housing and measure the inducer and exducer (two edges of the compressor blades) of the compessor wheel and check them up against turbo spec's from garrett...like from

http://www.capa.com.au/turbo_garrett.htm

give you a rough idea...easy way you can tell if its a gt series is by the blades of the turbine (exhaust side) which are curved abit insead of straight...
 
You must log in or register to reply here.
Top