A
Anonymous
Guest
hi all iv done my bottom crank pulley seal 3 times now and in the morrning iv got a bit of oil on the floor its doing my head in any ideas 
J
jasegould
Guest
How are you fitting the seal?? I did a subaru one and I lubed it up a bit too much and it leaked, fitted the next one dry (albeit a small smear or oil in the inside around the crank) and it was fine??
I
Innovate Performance
Guest
check the end float in the crank if there to much the seal will leak.
you will know if it is this you will feel the play by hand.
you will know if it is this you will feel the play by hand.
O
Olly
Guest
Front cover not correctly aligned has it been apart or orginal?
O
Odin
Guest
I'v just finished doing mine and what I found was, That there is a thin flat metal metal washer thingy that sit's under the seal. And if you did what I did and take the old seal out with a screw driver you can damage itbad boy said:hi all iv done my bottom crank pulley seal 3 times now and in the morrning iv got a bit of oil on the floor its doing my head in any ideas
.Lucky enough for me I had a spare oil pump cover in the garage with the seal still fitted :shock: 8)
, And I just removed the seal a bit more carefully this time as not to bend the metal washer 8) , And fitted it to mine with the new seal and it seems to all work fine 8) .rob