Turbo coolant and oil feed washers

[Wes]

Are these reusable?

I will be removing mani,turbo and exhaust downpipe while I drill and tap the mani studs as I have a few just spinning and a one that will need to be drilled out. I will be taking the whole lot off the engine and taking the feed pipes off the block and keeping them attaché on the turbo side.

 

[Wes]

oh and does anybody know torque spec of the stud for the manifold?

 

[Fast Guy]

The copper crush washers should be replaced.
You might be lucky if you reuse them if you're desperate, but I'd use new ones at risk of causing an oil leak.

 

[Wes]

Thanks, Makes sense to do it as I will be replacing most gaskets and studs.

Are they generic or only available from Nissan?

 

[Wes]

Just ordered from Nissan
6 x 1519303E0
2 x 15193P9000
£25.00

 

[Fast Guy]

Thanks, Makes sense to do it as I will be replacing most gaskets and studs.

Are they generic or only available from Nissan?

Even though it's a bit late to answer. I'd imagine if you knew the sizes you'd be able to get them somewhere else. (we used copped crush washers on a 1940s aircraft in the RAF in the 80s, so they're not exactly rare)

 

[fubar andy]

Just ordered from Nissan
6 x 1519303E0
2 x 15193P9000
£25.00

WWWHHHAAATTTT!!!!!!

 

[Wes]

WWWHHHAAATTTT!!!!!!

I Know right.