Search results

Get mine blow thru maf sensor which will measure more than 550 hp ;-)

Hello! i want a running engine OEM or forged. Please send me PM if you have one for sale. Thanks Sascha

Hi, i still have a problem with the oil pressure. Few months ago i had low oil pressure at all revs. Then i had put the engine out of the car and rebuild them. I had fit another block with new Mahle pistons, acl bearings and a new oil pump. After rebuild the oil pressure is same as...

Hi, i want a T3 exhaust manifold! Please send me PM if you have one for sale. Thanks Sascha

Thanks for the best information! But why it is possible that the pistons only can hold up to 500 hp?? If i have the best mixture of afr and not too much heat in the burning room i could not understand why they fail?? Now i have heard that much Nissan tuners here in germany fit the mahle...

He mean that the pin from the oil squirters can file away! You can not open the hole! !! Then you don't have oil pressure at idle.

Ahh that sound's nice! After i file off the pins they still hold the position? Many thanks for your help!

Hi rob, if you look here you can see the same prob! http://i272.photobucket.com/albums/jj194/sr20det_motor_build/contact1.jpg There i don´t can cut off...

Hello! i have a big problem. The oil squirters have contact at the bottom of the Mahle piston. Can i turn the squirters a little that it can work without problems? Thanks Sascha

Hi, i want a new 1.8mm head gasket. Please send me pm if you have one for sale. Thx Sascha

.....

Still wanted! If possible these numbers on the bottom E7 75 ..

Because i have bought an complete block which was made or not from an engine builder but after arrive i had strip them too check and then i had seen that one piston is damage.

Hi james! that´s nice if you could send me pics. Please send them too my email ;-)

24x25,6 is the size. I think it is the old input shaft....

Hello! Where can i get a alignment tool for clutch fitting? Thanks Sascha

closed Closed

Ok thanks for your help!

You had made the joke and not i! Here the pics:

These answer helped me! Many thanks... I give you right, but you can turn the discs and then??? Which is the side must show too the flywheel?? The bolts from backside or the center with the metal ring?