Supporting power

Mooser

Member
Hi Iv got my car run in after my build I'm now looking into getting some power out of it looking for 400hp
What supporting mods are recommended before mapping and on what software?
I'm looking at
A gt3071r .86 housing (need to find one)
3" elbow (bogdan hopefully)
3" downpipe (need to find)
Injectors (need to find) and no idea what size
Z32 maf (got)
And oil cooler (got)
Aftermarket ecu ( which one need to find)
Anything else Iv missed?
Been away from turbo cars for a while now so I'm a bit rusty and my r has been tucked away for the best part of 8-9 years

Thanks
 

Mad

Well-Known Member
Hi Iv got my car run in after my build I'm now looking into getting some power out of it looking for 400hp
What supporting mods are recommended before mapping and on what software?
I'm looking at
A gt3071r .86 housing (need to find one)
3" elbow (bogdan hopefully)
3" downpipe (need to find)
Injectors (need to find) and no idea what size
Z32 maf (got)
And oil cooler (got)
Aftermarket ecu ( which one need to find)
Anything else Iv missed?
Been away from turbo cars for a while now so I'm a bit rusty and my r has been tucked away for the best part of 8-9 years

Thanks
Hi,

The obvious ones if not already are exhaust and air filter

Oil cooler - not needed
Ecu - either apexi afc or a nistune remap
Boost controller
Updated fuel pump
Front mounted inter cooler ideally
Injectors - 550 will be ok but you will probably need a fuel pressure regulator. I'd recommend 600 plus
Upraised clutch
Updated gearbox ideally - quaife

Here is a useful guide - http://www.fusion-motorsport.co.uk/tech/tuning-guides/tuning-nissan/pulsar-gti-r
 

Mooser

Member
Sorry should have added what the car does have, it's got a front mount an air filter 3"decat and catback walbro 255 In tank feeding a swirl pot to an 044 to the rail it's got an avcr boost controller and an updated clutch and flywheel and an oem lsd transfer box updated brakes on the front and pads on the rear. Box wise I'm looking to get the stracher Motorsport brace put into my spare box and quaife gearset.

I literally just found fusions guide and will give them a call next week as I need to get my finger out and get this car done.

Cheers
 

Mad

Well-Known Member
Great, your on your way already :thumbsup:

Ed can do everything for you and set it up.

He is busy so keep trying if u don't get hold of him
 
Top