Search results

  1. projectgtir

    1992 Red GTIR For Sale

    Wish I had a 15k budget lol Gutted for you Steve . Hope everyone involved is I’m looking for a kind of project. The more standard the better . And ideally not black .
  2. projectgtir

    1992 Red GTIR For Sale

    Did this sell ?
  3. projectgtir

    Smo's Mag Featured, Restored & Resprayed (White) Shell For Sale

    Is this still for sale? Is there an echo in here in here in here
  4. projectgtir

    Pulsar wanted any condition

    Ok so ive been away from this forum for a around two years since i sold my r . i purchased an ep3 after and recently sold it . This was to make way for a brand new ford fiesta st but the waiting time is a joke so i have canceled it . So now im looking to kill to birds with one stone , as its...
  5. projectgtir

    Black r needs engine.

    Thanks mate I'm in Birmingham .longbridge area.
  6. projectgtir

    Black r needs engine.

    Bump price reduced 1650
  7. projectgtir

    Black r needs engine.

    Update. Handbrake cable now fitted ,car now has 12 months mot from today june 3rd. Just to say ive now bled the coolant system as the manual says and now it seems to be fine. Also had a fuse gone 3 steps up on right hand side above diag port ,dont know what this is but fans now come in ...
  8. projectgtir

    Black r needs engine.

    Tbh im not sure but as a ballpark i spose £2000 with everything mentioned but im open to sensible offers. Until now ive been in two minds weather to get a block off bob and bulid it up or buy a forged engine etc.. as it was a fantasic car when running as all pulsars are.
  9. projectgtir

    Black r needs engine.

    Sold!!!
  10. projectgtir

    Themostatic switch

    Thanks trip . Seem a diagram for another Nissan which had one in the rad . But we don't have one . My fans are not coming on . I've sent 12v to them and they work I've checked continuity from pin 1 on the relay to ground and to the fans and there is continuity . I them swap relays from the...
  11. projectgtir

    Themostatic switch

    Hi all , anyone know where this switch is .
  12. projectgtir

    thermostat

    Interesting read , ive had overheating issues too . Ive just checked my rad cap and found its a 1.1 bar cap . My themostat that was in the car at the time of overheating when checked was also operating very slow . Unfortunately mine overheated to the point where i had the dreaded mayo under the...
  13. projectgtir

    Wont rev past 2k rpm

    Yes its interesting in the sense that it shouldnt happen, maybe all pulsars are not wired how they should be . It would maybe explain all the misfire and electrical gremlins these cars seem to have . Mine especially . But unplugging it under the seat solved it for me , but why who knows . I...
  14. projectgtir

    Wont rev past 2k rpm

    Could be the cat temp sensor playing up . This causes some sort of limp home type thing. But basicly the car is undrivable. 1800-2000 rev limit and when you hit it the car goes back to idle speed. It happend to me a few months back . You usually get a light on the dash thats permanantly on . It...
  15. projectgtir

    what to do next

    Not as per the manual no . I've not undone the one on the block as Jambi talked about . When I put water in the rad I wait till water trickles out the bleed nipple on the stat housing. Close the nipple start the car turn fans on, temp to hot. Then Open nipple slowly so water trickles out then...
  16. projectgtir

    car loose's performance when hot

    Had this exact problem with my car when it was on the road ,sometimes it was rapid next minuete it would bog down. code 55 also. Also noticed it was only under load ,if you were to put the car in neutral and rev it would be fine. I changed plugs, leads, dizzy,rotor arm,coolant sensor.ignition...
  17. projectgtir

    what to do next

    checked the stat and it was opening but, i had removed it the last time it put the engine back together anyway . water pump was brand new from nissan for the first time i put it back together. Is it possible for the turbo housing to be leaking exhaust gas into water or water into oil etc...
  18. projectgtir

    what to do next

    Just an update . Head has been pressure tested and checked for straightness and is true and holding pressure so it's either block face or a crack in the block .
  19. projectgtir

    what to do next

    No other water leaks . New oe head bolts and oe gasket new oe water pump and crank pulley . To bleed the car heater on hot and full, bleed nipple on stat housing open until water comes through. Rad cap could be suspet . The amount of water going in the oil is stupid . Put brand new comma fully...
  20. projectgtir

    what to do next

    Thanks for the input guys,I'd like to solve this problem as I've spent alot of time on this engine now. It could just be the head and therefore I could just get a second hand head . My worst fear is the block has warped . Is there any specific place these engines tend to crack first or is it...
Top