Search results

i have one i will check on condition and upload a photo also by hatch do you mean the boot with spoiler

this is sold- 2016 sorry for late response

just a quick one anyone know of either reasonably priced starter motors r a good copany to get mine reconditioned cheers

cars still for sale and comes out from the spray shop this week or next

also to add the photos of the rust is drivers side which is getting repaired, and i also have the towing eye cap, ive just removed it incase it gets stolen

so i hope these photos work and people can now view them, the car is now in the work shop getting a new metal arch and drivers side replaced, and also getting the bonnet and bumper sprayed so this will be a genuine rust free example. my price has changed as im spending more to tidy up the body...

i know but i dont know how to upload them in a smaller size, but i can email or whattsapp them over to any genuine people. also to add its now gone to the spray shop where im getting the drivers side rear arch and whole side sprayed, and the front bumper and bonnet

hi all so the usual, Im not sure i actually want to sell but since ive had it rebuilt and mapped for 320 bhp, 2 and a half years ago i have only driven her 4000 miles. It just sits in a garage and im too busy to drive it as i spend my live in the van. So i think the time...

so turns out it was the dump valve, causing the issues.

no not missfiring, i did think maf ill do the obvious things and a full service see if that makes a differnce. fuel is new as was basically empty oil in exhaust is what i thought but has had a good hour just running so would of thought it might of gone but you never know. i checked for air...

so it had an engine rebuild and is 4k old. so i doubt a terraclean is required and what they ve told me so far is it was a static test and let run for half hour or so, and a 4 mile drive. its in need of a service but cant see how that would cause it. and has been mapped before the last mot. and...

so mot day last week, all good except a few issues. But the only one that is baffling me is high carbon and hydro carbon or whatever its called, basically one read 13% and should be below 3% and the other was only over by 100 or so but figure they are the same cause. but what im confused with...

I'm after a passenger side rear caliper in working order

As above the bit with lambda sensor on it stainless steel one please if they are any good As already got the cast iron one

ratchet spanner mole grips strong right arm some blood and finally done the, was sooooooooooooooooooooooooooooooooooooooo much fun

ok so im at a bit of a loss so im trying to remove my turbo and basically there is one stud that i cant get to and have no idea how its possible so any ideas. (standard manifold) its the bottom right one, in the centre, so far i have not removed any radiators or intercooler pipes, my...

so just wanting to know if anyone has used any other makes and recommends them as cant find any info on this site. and what they paid so im going to buy a new turbo a gt2871 r turbo technics are £825 ish ive seen a company called mambo, scooby lovers have used with no complaints as of yet...

ok buddy calmdown, i like ed, and i will only use him. i have no issues with him at all. This is just facts. This is a problem thats just happened and ironically not long after having it all remapped with a new ecu by ed, who i have spoken to about this and he also believes it to be turbo...

ed at fusion built it. no idea why it was underboosting. i can only assume as it was a standard ecu that it needed remapping ect. if im being honest makes no sense to me why after a rebuild it would be underboosting but hey ho thats life.

so how would i check as usually i would take it off and check for play in shaft on an older unit, but its a new unit ?