This is how I finally did it.
Put 15w40 mineral oil in it, drove the car for 150 kms........changed the oil and filter to 15w40 mineral....drove another 100 kms.
Put 10w60 semisyn and filter......drove for another 100 kms.....than put Mobil 1 10w60 full syn and map the car!:))))
The running...
Hi guys,
So....I have just measured the ride height on my gtir.
The results are as follows:
-front left 330 mm
-front right 340 mm
-rear left 350 mm
-rear right 360 mm
I think that this is weird!
Or, is it ok?
Please advice!
Thanks for all the input guys.
I have done something like this, until now.
-Changed the oil to a full mineral type
-Ran the car until 2500-3000 rpm for 200 miles
-Changed the oil and filter
-Checked the filter for impurities....
And this is what I've done until now:D
The flanges were machined flat and during welding bolted high tensile bolts so that they move.
I believe that the warping is minimal.....as I have checked each and every one of the elbows.
Sorry....
Hi Jon,
You can use both version of bolts, either the one provided or your old ones.
If you made the holes 0.5 mm bigger there will be no issue at all.
Secondhand gasket, is it's not damaged you can use it.
Brand new copper washers are always a good idea!
Mates, your appreciation is much valued.
I know.....it is not easy to fit it...and nothing fits like a factory piece. This is because it is hand made.
By the way......I will make a in tank surge tank.
Any interested?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.