Search results

I will be moving back to the US :usa: in July and since I can't import a GtiR, I'm going to import it in pieces .... well the important parts at least. :-D :chained: My plan is to swap the entire AWD running gear of the GtiR into an early 90's Nissan Sentra SE-R. It has been done a couple of...

I will be moving back to the US :usa: in July and since I can't import a GtiR, I'm going to import it in pieces .... well the important parts at least. :-D :chained: My plan is to swap the entire AWD running gear of the GtiR into an early 90's Nissan Sentra SE-R. It has been done a couple of...

I'm going to be there ... maybe not in my R but hopefully I will if all goes well with a new starter. If not then I will be there in my Audi S3. (the more sophisticated & younger german brother of the Pulsar) :-D

I went to start my car this morning and nothing. No clicking or movement of any kind from the motor. All the lights came on and did not dim when I tried to start the car. I connected jumper cables from my wife's car and still nothing. I took a ratchet and tried to bang on the starter motor a...

I'm going to be installing my Ogura clutch/flywheel combo tomorrow. I've read several how to guides around the internet so I don't think it will be too hard ... just time consuming. I have access to a lift and tons of tools so that should make it easier. I've bought a new release bearing ...

I have a set of Spax springs for the front. I just need a set of rear lowering springs. I don't really care what brand. Or a trade for a full set + cash

I found this hose that comes off the bottom of the intake manifold and goes no where. What does it do and where is it suppose to go? How bad is it that I've been driving around for years with it disconnected?

This is a cool website I stumbled on. Unfortunately, it is a little depressing as we are a dying breed by the looks of the stats. http://howmanyleft.com/vehicle/nissan_sunny_gtir_4wd#!tax

I suspected my injectors for maybe over fueling so I removed them and had them flow bench checked and cleaned. I Just reinstalled them today and #3 injector is spraying fuel out around the rubber insulator between the injector and the fuel rail. I pulled it off and checked the o-ring, it...

Hey guys, I bought a bunch of parts to get me around 300-350hp, including an Apexi Power FC. I read up online about how to install the PFC and how to initialize and do the 30 minute idle learn setup. I bought the PFC used from Bob at GTi-r-us about a year ago and he said that the previous owner...

Yo, Looking for a good set of 550cc injectors.