Search results

Ok after running at the weeked I couldnt get the 60ft time down!! And after around 90mph the car doesnt seem to gain much speed 24.18mph on the last 1/8th I guessing the car should be a lot quicker if i'm getting to 116mph ? Humm need to think what the problem could be... Reaction...

Can some one please let me know the setting you have for the injector correction with 700cc's ( sards's ) Ive set is as worked out from the manual, but the car is still running very rich Thanks Dave

Quick question Will the GTi Startermotor fit the GTiR ? Or does anyone have the code for the correct unit ? Thanks Dave

What results should i be lookin at on a hot engine with a 2mm head gasket and hks pisions ? I did a test when cold and got around 9.5bar ( 137 psi ) Anyone got any results ? Thanks Dave

Just found this old pic of the sideskirts on my pc, I like them anyways Dave

Hi all, Just taken my turbo off after havin smoke out the exhaust on tickover. Now I have the option of what to do next !!! The turbo was a Norris Designs Super T28 ( was runnin .5bar ), But dont look any diffrent to standard turbo ? So do I get my turbo re-build ? to what spec ? How...

Just had a go at fitting my Z32 Maf, Prob is that its shows 3.03 Volts at Key, the standard Maf shows .5 Volts When i try to start the car i get loads of black smoke, and it wont run Is the Maf Dead, or have I made a common error when connecting it ? tar Dave

Can somone let me know what type's of commander unit's will work with the GTiR Apexi Power FC Does anyone also have the code on the back ? Thanks Dave

Have ordered the FC-Datalog it software for the Apexi Power FC Ecu, Anyone else ordered it ? and how long did it take to arrive ? I've had no E-mail's back from them yet ? Thanks Dave

I'm just got my PFC Install, and hit a problem already !!! The car will fire up but die a few seconds later. unless i give it a bit of gas. I have an Apexi AVCR Fitted, But have read that they PFC comes setup for the Apexi Boost add on kit. ( I dont have the commander unit ) So what can I...

Ok, I've just had a go at fitted these wheels they are 15"and setup for a gtir. Problem is I have the hispec 300m 4 pot kit on the front, and they hit the caliper when tryin to fit, Do i have any options other than sell the wheels, or get smaller brakes Thanks Dave

Just thought id show you the progress on the sideskirts, 1st step and to spray with plastic primer, then sand back with 800 grit wet-n-dry Dave

Ok, The other day I was driving along, and the biting point was getting lower and lower, I went to change gear, and the pedel was stuck on the floor, I've so far .. tryed re-filling the clutch system, After this I removed the salve cylinder thinking this could be naf. but after removing...

Just about to order some new injectors for my R but what size should I get? I was thinking of 700cc but the price is the same as the smaller ones. ?? Am I going to have prob with using 700's ? I'm sure I'll mod the rest of the car over time to use the extra CC's its running ND Super...