Hi,
i still have a problem with the oil pressure. Few months ago i had low oil pressure at all revs.
Then i had put the engine out of the car and rebuild them. I had fit another block with new Mahle pistons, acl bearings and a new oil pump.
After rebuild the oil pressure is same as...
Thanks for the best information!
But why it is possible that the pistons only can hold up to 500 hp?? If i have the best mixture of afr and not too much heat in the burning room i could not understand why they fail??
Now i have heard that much Nissan tuners here in germany fit the mahle...
Hi rob,
if you look here you can see the same prob!
http://i272.photobucket.com/albums/jj194/sr20det_motor_build/contact1.jpg
There i don´t can cut off...
Hello!
i have a big problem. The oil squirters have contact at the bottom of the Mahle piston. Can i turn the squirters a little that it can work without problems?
Thanks
Sascha
Because i have bought an complete block which was made or not from an engine builder but after arrive i had strip them too check and then i had seen that one piston is damage.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.