Thought I would give you all a quick overview of Knockhill yesterday.
We had a fantastic day and to those who we met it was a pleasure to meet you all.
I appreciate there is always someone who is going to do things differently but we are extremely happy with yesterdays results and the general...
I wont say to much bob and you are right to a extent,but wouldnt it be good for the pulsar to get the recognition it deserves and compete in the time attack series and you never no it could even surprise a few people and bring the status of the car back up to where it belongs.
here we go again
here we go again
i have read through the post regarding grants manifold problem and to a extent it is true,grant orderd a manifold through us a tublar one and there was quite a delay in grant receiveing this mainly down to our exhaust manifold fabricator cutting his finger...
haha you make me laugh you do pobody, as for the are we running bit it may be possible we will have some pics up in the next few weeks,ro sunny, no there not crap quite a tool really just that nobody has ever really pushed them.
here we go again
i have read through the post regarding grants manifold problem and to a extent it is true,grant orderd a manifold through us a tublar one and there was quite a delay in grant receiveing this mainly down to our exhaust manifold fabricator cutting his finger off.
I think grant...
When mapping cars we take all neccaserry precautions we monitor the fuel with a lamba reader
We listen to knock by the way of stephoscopes and also use the power fc knock level indicator
A fuel pressure gauge is fitted to the vechile
The boost pressure is monitored by the boost controller in...
Faults found
Billy had advised us he had replaced the oil return on the turbo and it was crimped repaired
Boost pipe fastener to inlet manifold faulty and not clamping replaced
Intake system collapseing rectified
These faults were all rectified before any mapping took place
just to clarify,Billys car was dropped off to us with the instruction of replaceing the cylinder head for a ported one due to the stem seals being faulty,this job was carried out and the headgasket was replaced for a thicker 2mm gasket on doing the head swap we run some test on the engine to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.